| By replenishing water vapor, the water enters a water storage tank, and then pumps the water through the flow control valve to the diverter head, where the water is evenly sprayed onto the surface of the ice maker on site, and flows across the wall of the ice maker like a curtain of water. The water that has been cooled to ice by water, but has not been evaporated and solidified, will pass through the storage tank of the packaging container, boldly starting to cycle work. The leaving heat is re-directed back into the wall of the ice maker to reduce low-temperature gas refrigerant. In this way, a thin film of water is formed between the ice and the wall of the evaporation tube. This layer of water will act as a lubrication when it falls freely into the groove below by the gravity of the ice. The water produced during the ice picking cycle will pass through the water tank and return to the water storage tank, which can also prevent the wet ice from being left by the machine. 1. The chilled water pump of the water storage tank continuously circulates through the plate-type or compartmentalized evaporator; 2. After the vacuum movement, it is vaporized by -compression-condensation-condensation-throttling-condenser with low temperature evaporation of -10 degrees to -18 degrees. Chilled water in 0 degree temperature water continuously forms a layer of ice on the surface of the lower temperature evaporator. When the ice layer refrigerant reaches a certain life value, after the ice making process reaches the controlled set temperature through the temperature, it is combined with the defrost solenoid valve to often use heat transfer to remove the ice, and then realize a cycle. The water is pumped into the water vapor, and the water enters a water storage tank. The water is pumped to the shunt pipe through the water. The shunt pipe flows to the Ice Machine Evaporators cooled by the low-temperature cooling water coolant at the same time. The water is cooled to the freezing point, and the ice cubes cooled to the freezing point When it arrives, it enters the de-icing state, and enters the de-icing state, and the heat energy sucked out of the body is directed to the evaporator through the reversing valve to reduce the low temperature of these refrigerants. In this way, a water film is formed between the ice cubes and the evaporator, and the water film de-evaporates the ice cubes. When the ice cubes fall freely into the ice storage tank below by the action of gravity. |
China manufacturers 